GE IC670CHS001 I/O Terminal Block with Barrier Terminals
General info
| Manufacture | GE |
| Item No | IC670CHS001 |
| Article number | IC670CHS001 |
| Series | GE FANUC |
| Origin | United States（US） |
| Dimension | 180*180*30(mm) |
| Weight | 0.9 kg |
| Customs Tariff Number | 85389091 |
| Type | I/O Terminal Block with Barrier Terminals |
Detailed data
GE IC670CHS001 I/O Terminal Block with Barrier Terminals
I/O terminal blocks are universal wiring bases that provide module mounting, backplane communications, and user connection terminals. Two modules can be mounted on one terminal block. The modules are fixed to the terminal block with screws to prevent vibration. The modules can be removed without disturbing the field wiring.
The I/O Terminal Block with Isolated Terminals (Cat. No. IC670CHS001) has 37 terminals. The A and B terminals are normally used for power connections to the terminal block. The remaining terminals are individual terminals for I/O wiring.
Each terminal on the I/O terminal block or auxiliary terminal block (with isolated terminals) can accommodate up to two AWG #14 (2.1 mm2) to AWG #22 (0.35 mm2) wires. Use copper wire rated for 90 degrees Celsius. The recommended terminal torque is 8 in/lbs (7-9).
The safety ground wire should be AWG #14 (avg 2.1mm2 cross section), not more than 4 inches (10.16 cm) long.
The I/O terminal block IC670CHS101 allows hot insertion/removal of modules without affecting the bus interface unit or other modules in the I/O station. Hot insertion/removal is only possible in non-hazardous locations.
Compatibility
The I/O Terminal Block IC670CHS101 has a protruding alignment slot at each module position. It must be used with modules with catalog number suffix J or above. These modules have a protruding tab that plugs into the alignment slot. Hot insertion/removal of modules in the I/O station requires Bus Interface Unit version 2.1 or higher.
Mixing IC670CHS10x terminal blocks with IC670CHS00x terminal blocks in the same I/O station is not recommended.
I/O Terminal Blocks IC670CHS101 and IC670CHS001B or later have a metal grounding strip. They must be used with a grounded conductive DIN rail. Do not use this terminal block with Revision A I/O Terminal Blocks or BIU Terminal Blocks IC670GBI001 that do not have a metal grounding strip; this will result in poor system noise immunity.
